Ritron Quick Talk Manuel du propriétaire télécharger pdf (Page 15)

Page 13For assistance, call RITRON at 800-872-1872, or go to www.ritron.com

qtm9322b.pm5

What is the purpose of recording a unique Voice Phrase

for the Low Battery Message? When it senses the

installed batteries are nearly run down, Quick Talk will

transmit one time each hour the factory-programmed

message: "Low Battery". If you maintain several Quick

Talk transmitters within radio range of each other, you may

customize this feature to easily determine which unit

needs new batteries.

Do I need to program this feature? If you use only one

Quick Talk in any area, or if you regularly change Quick

Talk batteries, the factory-programmed message may be

sufficient for your application. You can skip to the next

section.

To Program the Low Battery Alert Phrase:

a. Pick up the telephone receiver, wait for the beep,

then dial "35".

Quick Talk sounds three short tones to prompt you

to begin speaking . . .

b. Record a phrase no longer than one and one-half

(1.5) seconds, indicating Low Battery, and identify-

ing the Quick Talk unit.

For example say: "Low Battery Five".

c. Hang up the telephone when you are done speak-

ing.

d. Pick up the telephone and dial "45" to hear your

phrase played back through the telephone receiver.

e. If you are not pleased with the results, you may

return to Step a above and record again.

NOTE: We suggest you physically mark the Quick

Talk with the same unique identifier

(number) you recorded.

RECORDING A UNIQUE LOW BATTERY

MESSAGE TO IDENTIFY A QUICK TALK

What is the purpose of restarting the Quick Talk? If you

have changed message schedules or limits, restarting the

Quick Talk ensures that all of internal clocks and counters

are set properly.

Do I need to restart the Quick Talk? It is best if you do.

To Leave Telephone Programming Mode and Restart the

Quick Talk:



Pick up the telephone receiver, wait for the beep

and dial "999".

Quick Talk responds with a single short tone.

NOTE: Be certain to hang up and to disconnect the

telephone from Quick Talk.

RESTART THE QUICK TALK WHEN YOU

ARE DONE PROGRAMMING

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 27 28

Commentaires sur ces manuels

Pas de commentaire

Ritron Quick Talk Manuel du propriétaire Page 15

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes vidéo pour voitures Ritron Quick Talk